In-Line Profile Measurement System For Large Diameter Pipe #(--edpnumber)#

In-Line Profile Measurement System For Large Diameter Pipe

When used in final inspection of cut pipes, Profile360Gäó produces an automated dimensional inspection report for the Outer Diameter (OD) and Out-of-Round (OOR) of the pipe ends and body to assure compliance with API and other standards. When installed on the pipe mill, the measurements can be used to fine-tune the tooling during a set up change, and then alarm whenever OD or OOR values approach the allowable limits, so that an operator can intervene before a quality fault occurs.

Product Testimonials

Contact Starrett


  • Profile360Gäó-600 Automatically Measures Pipe OD And OOR From 6" - 24" (150 - 600Mm) at two locations: In-Line before cutting, and in final inspection
  • Profile360Gäó Utilizes CrosscheckGäó Line-Laser Sensors, developed & optimized by Starrett-Bytewise for the range and accuracy required for pipe mills
  • A single measurement cycle instantaneously acquires about 5,000 data points (24" pipe) in a precise cross-sectional plane in a matter of milliseconds
  • Profile360Gäó is inherently reliable due to its simple design


  • Made in America: Yes
  • Max OD: 300, 600, and 1600 mm
  • Accuracy OD and OOR: 0.1, 0.15 and 0.2 mm
  • Accuracy Length: 0.05%
  • Laser Classification, IEC: 3R IEC 60825-1
  • Laser Classification, CDRH: IIIa CDRH
  • Laser Frequency, Maximum: 14 Hz
  • Power 220V: 20 A
  • Low Voltage Directive: 2014/35/EU (LVD)
  • EMC Directive: 2014/30/EU (EMC)
  • Machinery Directive: 2006/42/EC (MD)
  • Hazardous Substances: 2011/65/EU (ROHS)


    Precision Hand Tools (Catalog 33)

    612 page catalog featuring precision hand tool, force measurement, vison systems, optical comparators, laser measurement, and flat stock.

Product Testimonials

    Write a product review