52590

568A V-Block and Clamp 52590

Starrett V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece. V-Block and Clamp.


Contact Starrett

Features

  • Hardened steel, precision ground parallel and square
  • V-grooves are ground central and parallel to the sides and base - perfect alignment in matched pairs
  • Clamps have screw holes at 45º and 90º to hold either square or round work
  • Stepped groove construction permits high or low clamp mounting or small or large work
  • Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
  • 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
  • Each block is 2-1/2" long x 3" wide x 2" high (63 x 75 x 50mm)

Specifications

  • Capacity (in): 2" Dia. Round; 1-7/16" Square (1-9/16" with Screw at Top)
  • Capacity (mm): 50mm Dia. Round; 36mm Square (40mm with Screw at Top)

3D CAD Files / Exploded Parts Diagram

    !This product does not have any related 3D files.

Product Testimonials

    Write a product review

    California Proposition 65 Warning

      WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov